Search results for "Reynolds stre"
showing 10 items of 11 documents
Acoustic doppler velocity profiler for velocity and turbulence measurements in a large amplitude meandering flume
2008
Flow over deformed bed of a meandering laboratory channel is experimentally investigated. The velocity components have been obtained using an Ultrasonic Doppler Profiler (DOP2000) that measures the instantaneous flow velocity profile along the probe direction. In this work, some results obtained in peculiar sections along the channel are reported. A refined mesh of the measurement points has been used for each considered cross-section. The analysis of the collected data essentially confirms that when the aspect ratio is small the secondary circulation assumes great importance and, in accordance with previous findings, a second counter-rotating secondary circulation cell appears near the fre…
A dynamic subgrid-scale tensorial eddy viscosity model
1999
In the Navier-Stokes equations the removal of the turbulent fluctuating velocities with a frequency above a certain fixed threshold, employed in the Large Eddy Simulation (LES), causes the appearance of a turbulent stress tensor that requires a number of closure assumptions. In this paper insufficiencies are demonstrated for those closure models which are based on a scalar eddy viscosity coefficient. A new model, based on a tensorial eddy viscosity, is therefore proposed; it employs the Germano identity [1] and allows dynamical evaluation of the single required input coefficient. The tensorial expression for the eddy viscosity is deduced by removing the widely used scalar assumption of the …
Wind- and tide-induced currents in the Stagnone Lagoon (Sicily)
2011
The hydrodynamic circulation is analyzed in the coastal lagoon of Stagnone di Marsala, a natural reserve located in the north-western part of Sicily, using both experimental measurements and numerical simulations. Field measurements of velocities and water levels, carried out using an ultrasound sensor (3D), are used to validate the numerical model. A 3D finite-volume model is used to solve the Reynolds-averaged momentum and mass balance differential equations on a curvilinear structured grid, employing the k– $${\varepsilon}$$ turbulence model for the Reynolds stresses. The numerical analysis allows to identify the relative contribution of the forces affecting the hydrodynamic circulation …
Effects of irregular two-dimensional and three-dimensional surface roughness in turbulent channel flows
2012
Abstract Wall-resolved Large Eddy Simulation of fully developed turbulent channel flows over two different rough surfaces is performed to investigate on the effects of irregular 2D and 3D roughness on the turbulence. The two geometries are obtained through the superimposition of sinusoidal functions having random amplitudes and different wave lengths. In the 2D configuration the irregular shape in the longitudinal direction is replicated in the transverse one, while in the 3D case the sinusoidal functions are generated both in streamwise and spanwise directions. Both channel walls are roughened in such a way as to obtain surfaces with statistically equivalent roughness height, but different…
Experimental and Numerical Study on the Flow Field and Friction Factor in a Pressurized Corrugated Pipe
2015
An experimental campaign including measurement of pressure drops and velocity profiles was conducted on the pressurized flow in a commercial corrugated pipe. The results show that the empirical graphs suggested by Morris in the fifties may produce inaccurate assessments of the friction factor, in particular, for low Reynolds numbers. The experimental data was then reproduced by means of a numerical model with the large eddy simulation (LES) technique. The friction factor behavior for low and relatively high Reynolds numbers was thus investigated. The numerical simulations were in good agreement with the experimental results, showing the LES suitability to predict the effect of the pipe wall…
Large eddy simulations on the effect of the irregular roughness shape on turbulent channel flows
2019
Abstract Large Eddy Simulations (LES) are carried out to investigate on the mean flow in turbulent channel flows over irregular rough surfaces. Here the attention is focused to selectively investigate on the effect induced by crests or cavities of the roughness. The irregular shape is generated through the super-imposition of sinusoidal functions having random amplitude and four different wave-lengths. The irregular roughness profile is reproduced along the spanwise direction in order to obtain a 2D rough shape. The analysis of the mean velocity profiles shows that roughness crests induce higher effect in the outer-region whereas roughness cavities cause the highest effects in the inner-reg…
CFD simulations of early- to fully-turbulent conditions in unbaffled and baffled vessels stirred by a Rushton turbine
2021
Abstract Laboratory scale unbaffled tanks provided with a top cover and a baffled tank both stirred by a Rushton turbine were simulated by carrying out RANS simulations. Three different turbulence models were adopted (k- ω SST, k- e and the SSG Reynolds stress model) to predict the flow field and the relevant performance parameters (power and pumping numbers) of the tank operated from early to fully turbulent conditions. CFD results were compared with literature experimental data and DNS simulation results to validate and properly compare the models. In the range of Reynolds numbers investigated, results showed that, for the unbaffled tank, the SSG model based on Reynolds stresses is a bett…
Turbulence structures over irregular rough surfaces
2010
Turbulent flow in a channel with irregular two-dimensional rough surfaces is analysed through wall-resolving large eddy simulation (LES). Both walls of the channel are roughened through the superimposition of sinusoidal functions having random amplitude and four different wavelengths. The downward shift of the velocity profile in the log region due to the roughness, known as roughness function, is well captured in the simulations. The spanwise and wall-normal turbulence intensities are found to increase with the roughness height, while the streamwise component decreases. The analysis of the Reynolds stress anisotropy tensor highlights a tendency towards isotropisation, confirmed by the vort…
Three-dimensional numerical simulations on wind- and tide-induced currents: The case of Augusta Harbour (Italy)
2014
The hydrodynamic circulation in the coastal area of the Augusta Bay (Italy), located in the eastern part of Sicily, is analysed. Due to the heavy contamination generated by the several chemical and petrochemical industries active in the zone, the harbour was declared a Contaminated Site of National Interest. To mitigate the risks connected with the industrial activities located near the harbour, it is important to analyse the hydrodynamic circulation in the coastal area. To perform such analysis, a parallel 3D numerical model is used to solve the Reynolds-averaged momentum and mass balance, employing the k-e turbulence model for the Reynolds stresses. The numerical model is parallelized usi…
Numerical prediction of turbulent flow and heat transfer in helically coiled pipes
2010
Abstract Computational results were obtained for turbulent flow and heat transfer in curved pipes, representative of helically coiled heat exchangers. Following a grid refinement study, grid independent predictions from alternative turbulence models ( k – ɛ , SST k – ω and RSM– ω ) were compared with DNS results and experimental pressure drop and heat transfer data. Using the SST k – ω and RSM– ω models, pressure drop results were in excellent agreement with literature data and the Ito correlation. For heat transfer, the literature is not comparably complete or accurate, but a satisfactory agreement was obtained in the range of available data. Unsatisfactory results, both for pressure drop …